Drilling Into Concrete Wall Condo

Remove any concrete dust then press the anchor into the hole until it is flush with the surface.

Drilling into concrete wall condo.

These tools fracture the concrete through rapid hammering then drill to scoop out the broken material. If your wall covering is sandy plaster then you would attach light shelves and pictures by pre drilling holes with a masonry bit and using expanding anchors or toggle bolts. If you re just drilling one or two holes for a small project a regular drill is fine. Just to give you an idea drilling a 1 inch hole in a 4 inch concrete slab using a hammer drill would probably take around 60 seconds.

While holding the drill perpendicular to the ceiling surface press the trigger and begin to drill into the concrete using the hammer action option on the drill. If you do hit a pipe williams. Usually diamond or carbon coated drill bits are what you will need. Buy or rent a good hammer drill.

One rule of thumb is to be especially careful when drilling into any walls that connect to your bathroom or kitchen basically any wall that s likely to have pipes. If you have to drill into a concrete living room you need to use a hammer drill fitted with tungsten carbide masonry bits. However drilling concrete is much easier with a hammer drill or a rotary hammer for large jobs. It would take a shorter time using a rotary hammer approximately 20 seconds.

The hole should be slightly smaller than the maximum width of the. Match the correct anchor size to that of the concrete screw. You will definitely need a drill bit meant for concrete. This will depend on the thickness of the concrete the hole size you want and the type of concrete drill you re using.

If necessary tap. A regular steel bit is not hard enough to make a clean hole and will just over heat and break if you even try. It s not hard but drilling concrete does take a lot longer than drilling through wood or metal. Drilling into concrete walls with a normal drill can be very frustrating and the results very untidy and disappointing.

Heavy shelves or cabinets will require screwing to a stud which you are referring to as a beam. Then you ll need to insert concrete anchors and then your fasteners screws. Next you are going to need a good concrete drill bit.